JVC RX-8040B manual Cassette deck

Cassette deck

You can connect either a cassette deck or an MD recorder to the TAPE/MD jacks. When connecting an MD recorder, see below.

Cassette deck

To audio input To audio output

Right / Left

	OUT
R	(REC)
	TAPE
L	/ MD	L
	IN
	(PLAY)
		R

MD recorder

You can connect either an MD recorder or a cassette deck to the TAPE/MD jacks. When connecting a cassette deck, see above.

Video component connections

Use the cables with RCA pin plugs (not supplied).

Connect the white plug to the audio left jack, the red plug to the audio right jack, and the yellow plug to the video jack.

•If your video components have S-video (Y/C-separation) and/or component video (Y, PB, PR) terminals, connect them using an S- video cable (not supplied) or component video cable (not supplied). By using these jacks, you can get better picture quality in the order:

Component video > S-video > Composite video

•If your video components have digital audio output terminal, connect them using the digital cords explained in “Digital connections” (see page 14).

If your video components have an AV COMPULINK jack

See also page 53 for detailed information about the connection and the AV COMPULINK remote control system.

IMPORTANT:

This receiver is equipped with the following video jacks—composite video, S-video and component video jacks. You can use any of the three to connect a video component.

However, the video signals from one type of these input jacks are transmitted only through the video output jacks of the same type.

Therefore, if a recording video component and a playing video component are connected to the receiver through the video jacks of different type, you cannot record the picture. In addition, if the TV and a playing video component are connected to the receiver through the video jacks of different type, you cannot view the playback picture on the TV.

English

MD recorder

To audio input To audio output

Right / Left

	OUT
R	(REC)
	TAPE
L	/ MD	L
	IN
	(PLAY)
		R

Note:

When connecting an MD recorder to the TAPE/MD jacks, change the source name to “MD,” which will appear on the display when it is selected as the source. See page 24 for details.

Video camera

The VIDEO input jacks on the front panel (inside the front door) are convenient when connecting and disconnecting the component frequently.

	To audio output
	To composite video
	output
	To S-video output
L R	To optical digital output

DIGITAL S-VIDEO VIDEO L—AUDIO—R

VIDEO

Video camera

Note:

When using the digital input terminal, select the digital input mode correctly. For details, see “Selecting the Analog or Digital Input Mode” on page 22.

11