24.Press a 50mm Square Inner Cap (43) into a Butterfly Arm (20).
Wet a Fly Handle (66) and the inside of a Long Foam Pad (97) with soapy water. Slide the Foam Pad onto the Handle.
Attach a Fly Handle (66) to the Butterfly Arm (20) with two M10 x 25mm Button Screws (60) and two M10 Washers (74).
Repeat this step with the other Butterfly Arm (not shown). Make sure that the Fly Handle is oriented as shown in step 25.
25.Lubricate an M10 x 80mm Bolt (86) with grease. Attach the left Butterfly Arm (20) to the Left Fly Pivot (21) with the Bolt and an M10 Nylon Locknut (75).
Attach the right Butterfly Arm (20) to the Right Fly Pivot (22) in the same manner.
Cable Assembly
26.IMPORTANT: Refer to the CABLE DIAGRAMS on pages 27 and 28 for help identifying the cables.
Locate the Butterfly Cable (64). Attach the Cable to the Left Fly Pivot (21) with an M8 x 58mm Shoulder Bolt (89), two M8 Washers (90), and an M8 Nylon Locknut (54).
27.Wrap the Butterfly Cable (64) over a
(40).Attach the
(39)to the bracket on the Left Upright (6) with an
M10 x 60mm Bolt (82) and an M10 Nylon Locknut
(75).Make sure that the Cable Trap is turned to hold the Cable in the groove of the
24 |
|
|
| 20 |
|
| 97 | 66 |
|
| |
74 |
|
|
60 |
|
|
| 43 |
|
25 |
|
|
75 |
|
|
|
| 20 |
| 86 |
|
21 | Lubricate |
|
22 |
|
|
20 |
|
|
26 | 89 |
|
|
| |
| 64 |
|
| 90 |
|
| 21 |
|
| 90 |
|
| 54 |
|
27 | 82 |
|
|
| |
39 |
| |
| 40 |
|
| 64 |
|
6 |
|
|
75 |
|
|
14
