28.Wrap the Butterfly Cable (64) under a 90mm Pulley (38). Attach the Pulley and a Cable Trap (37) between the second set of holes from the top of the two Pulley Plates (36) with an M10 x 48mm Bolt (23) and an M10 Nylon Locknut (75). Make sure that the Cable Trap is turned to hold the Cable in the groove of the Pulley.
29.Wrap the Butterfly Cable (64) over a
(40).Attach the
(39)to the bracket on the Left Upright (6) with an
M10 x 60mm Bolt (82) and an M10 Nylon Locknut
(75).Make sure that the Cable Trap is turned to hold the Cable in the groove of the
30.Attach the Butterfly Cable (64) to the Right Fly Pivot (22) with an M8 x 58mm Shoulder Bolt (89), two M8 Washers (90), and an M8 Nylon Locknut (54).
31.Locate the Low Cable (63). Route the Cable under a 90mm Pulley (38). Attach the Pulley inside the bracket on the Left Base (2) with an M10 x 45mm Bolt (78) and an M10 Nylon Locknut (75).
28 |
|
| 75 |
| 37 |
| 38 |
| 64 |
| 36 |
| 36 |
| 23 |
29 |
|
82 | 6 |
39 40 | |
| 75 |
| 64 |
30 |
|
| 64 |
| 89 |
| 90 |
| 22 |
| 54 |
31 |
|
| 38 |
| 75 |
| 2 |
| 78 |
| 63 |
15
