Gold's Gym GGSY69530 Cable Trap is turned to hold the Cable Groove of the Pulley, Locknut yet

41. Wrap the High Cable (61) over a 90mm Pulley	41
(38). Attach the Pulley to the Right Top Frame
(10) with an M10 x 45mm Bolt (78) and an M10						10
Nylon Locknut (75).						38
		75				78
						61
42. Wrap the High Cable (61) under a 90mm Pulley	42
(38). Attach the Pulley and a Cable Trap (37) to
the second set of holes from the top of the			37
Double “U”-bracket (41) with an M10 x 48mm Bolt					61
(23) and an M10 Nylon Locknut (75). Make sure						38
the Cable Trap is turned to hold the Cable in
the groove of the Pulley.			75			41
						23
43. Route the High Cable (61) up through the Right	43	85		61
Top Frame (10) and over a 90mm Pulley (38).						38
Attach the Pulley inside the Top Frame with an		74
M10 x 78mm Bolt (85), two M10 Washers (74),
two 17mm Spacers (58), and an M10 Nylon		58
Locknut (75).
		10				74
						58
						75
44. Route the High Cable (61) over a 90mm Pulley	44			61
(38) and down through the Right Top Frame (10).			38
		75
Attach the Pulley inside the Top Frame with an
		74		10
M10 x 78mm Bolt (85), two M10 Washers (74),
two 17mm Spacers (58), and an M10 Nylon		58
Locknut (75).					74
				58
					85
45. Locate the Long Cable (62). Attach the eyelet	45
on the Cable to the Right Upright (5) with an M10
x 110mm Bolt (88), an M10 Small Washer (33),
and an M10 Nylon Locknut (75). Do not tighten		75
the Locknut yet.
				5		33
					62	88

18