20.Lubricate an M12 x 102mm Bolt (81) with grease. Attach the Press Frame (14) to the Right Base (1) with the Bolt and an M12 Locknut (95). Make sure the hole is closer to the indicated side of the Press Frame. Do not overtighten the Locknut; the Press Frame must be able to pivot easily.
21.Press a 50mm Square Inner Cap (43) into a Press Arm (15). Press two 25mm Round Inner Caps (65) into the Press Arm.
Wet the handles on the Press Arm (15) with soapy water. Slide two Grips (68) onto the han- dles.
Attach the Press Arm (15) to the Press Frame
(14)with two M10 x 70mm Bolts (87) and two
M10 Nylon Locknuts (75).
Attach the other Press Arm (15) to the Press Frame (14) in the same manner.
22.Press two 50mm Square Inner Caps (43) into the Leg Lever (18).
Lubricate an M10 x 78mm Bolt (85) with grease. Orient the Leg Lever (18) as shown and attach it to the Left Leg (8) with the Bolt and an M10 Nylon Locknut (75). Do not overtighten the
Locknut; the Leg Lever must be able to pivot easily.
23.Lubricate both axles on the Left Top Frame (11) with grease.
Slide the Left Fly Pivot (21) onto the indicated axle on the Left Top Frame (11). Set two 25mm Retainer Rings (53) on a 25mm Round Outer Cap (47). Make sure the teeth on the Rings are toward the Cap, as shown in the inset draw- ing. Tap the Retainer Rings and Outer Cap onto the axle. Repeat with the Right Fly Pivot (22).
20 |
|
|
| 14 |
|
| Hole |
|
| 95 |
|
| 81 |
|
| 1 |
|
|
| Lubricate |
21 |
|
|
15 | 68 | 43 |
| ||
|
| |
|
| 65 |
| 75 | 15 |
|
| |
87 | 14 |
|
|
| |
22 | 75 | 43 |
|
| |
85 |
|
|
|
| 18 |
Lubricate | 8 | Small |
|
| |
|
| Slot |
|
| 43 |
23 |
| 11 |
|
| |
|
| Axle |
| 22 |
|
Axle |
| 21 |
53 |
| 53 |
|
| |
47 |
| 47 |
|
|
13
