If you purchase the optional chest pulse sensor (see page 22), follow the steps below to install the re- | ||||
ceiver included with the chest pulse sensor. |
|
|
|
|
1. Make sure that the power cord is unplugged. | 1 |
|
|
|
Remove the indicated #8 x 1/2" Screw (2) from |
|
|
| |
the Access Door (123) on the back of the con- |
|
|
|
|
sole assembly. |
|
|
|
|
|
|
| 123 | Console |
|
| 2 | Assembly | |
|
|
|
| |
2. Next, hold the receiver so that the antenna is | 2 |
|
|
|
oriented as shown. Peel the paper backing off |
| Receiver | ||
the pad on the bottom of the receiver. Press the |
|
| ||
receiver onto the Access Door (123) in the loca- |
|
|
| Antenna |
tion shown. |
|
|
| |
|
|
|
| 123 |
3.Connect the wire on the receiver to the wire ex- tending from the console assembly. Make sure that no wires are pinched. Reattach the Access Door (123) to the console assembly with the #8 x 1/2" Screw (2). Discard the other wires included with the receiver.
3 |
|
|
| Wires | Console |
2 | 123 | Assembly |
|
|
12
