Remove the three #8 x 3/4" Screws (1) and care- fully pivot the Motor Hood (63) off.
63 | 1 |
|
Locate the Reed Switch (77) and the Magnet (51) |
|
|
on the left side of the Pulley (52). Turn the Pulley |
|
|
until the Magnet is aligned with the Reed Switch. |
|
|
Make sure that the gap between the Magnet and | 1/8 in. |
|
the Reed Switch is about 1/8 in. (3 mm). If neces- |
| |
sary, loosen the #8 x 3/4" Clamp Screw (15), move |
| 51 |
the Reed Switch slightly, and then retighten the | 77 | |
Screw. Reattach the Motor Hood (not shown). If | 52 | |
necessary, reattach the #12 x 2" Screws (not | Top |
|
shown). Run the treadmill for a few minutes to | View |
|
check for a correct speed reading. |
| |
PROBLEM: The incline of the treadmill does not change correctly |
|
|
SOLUTION: a. With the key in the console, press one of the Incline buttons. While the incline is changing, re- move the key. After a few seconds,
PROBLEM: The walking belt slows when walked on
SOLUTION: a. Use only a
formance may decrease and the walking belt may become damaged. Remove the key and UNPLUG THE POWER CORD. Using the hex key, turn both idler roller bolts counterclockwise, 1/4 of a turn.
When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 2 to 3 in. (5 to 7 cm) off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walk- ing belt is properly tightened.
c. If the walking belt still slows when walked on, see the front cover of this manual.
26
