![](/images/new-backgrounds/1201538/20153817x1.webp)
Follow these steps to run Auto Setup, which will set the clock and save local channels automatically.
POWER
press
LANGUAGE/LANGUE
1 English
2 Français
Select =
Choisir =
press 1 or 2
C o n n e c t A n t e n n a o r
C a b l e a n d P r e s s M E N U
press
S e a r c h i n g F o r C h a n n e l s
P l e a s e W a i t . . .
S e t t i n g t h e C l o c k
P l e a s e W a i t . . .
Ch03
1S E T M E N U L A N G U A G E
The first time you turn on your
2C O N F I R M A N T E N N A / C A B L E C O N N E C T I O N
If you have not already done so, make sure you have connected an antenna or basic cable to the “IN (FROM ANT.)” jack on the VCR back panel. Press MENU to continue.
3R U N A U T O S E T U P
As soon as you press MENU, the
Auto Channel Search – Automatically detects the source of incoming channels (antenna or cable) and then searches for all active channels in your area.
Auto Clock Set – Automatically sets the VCR’s internal clock, which is necessary for accurate timer recording.
•This procedure may take a few minutes to complete. When finished, the VCR will display the lowest channel found.
•Please proceed with Chapter 2 for a Quick Tour of the
A U T O S E T U P
N O T E S
•If no channels were found in your area, the VCR will alert you and then display the “Channel Settings” menu; see page 39 to search for channels manually.
•If Auto Setup was unable to detect the time, the VCR will alert you and then display the “Set Month” menu; see page 37 to set the clock manually.
1 - Getting Started
3