13

Back Panel connections

There are three connections on the back panel.

1)The jack for the power adapter. Please plug the supplied power adapter into the radio’s power adapter jack then plug the other 2 prong end into the wall.

2)Stereo headset jack connection. The headset jack connection can be used to listen to music in private via your personal headset/headphones (not provided).

3)Stereo RCA jacks. These connections connect to your stereo’s audio input jacks or powered speakers.

Steps for Connecting Your Radio to Your Wireless Network

Getting Started

Step 1 - Power up the radio - 1st time set up

Connect one end of the AC Power cord to the back of your SOLO and the other end to the available wall plug. The radio can be switched on or off with the STANDBY/ON button. The STANDBY/On button is

marked on your radio with this symbol. If only the clock is displayed on the top of the display, the unit is in standby mode. Please turn the radio on before going to the next step.

CAUTION: Use only the power adapter supplied with SOLO. Connecting a power supply with a different rating will cause permanent damage to SOLO and may be hazardous and will void the warranty.

After you turn the radio on it will briefly display the following:

Grace Digital Radio

After a few seconds, the screen will change to show:

Page 13
Image 13
Grace GDI-IRA500 Steps for Connecting Your Radio to Your Wireless Network, Back Panel connections, Grace Digital Radio