Troubleshooting
Troubleshooting
Check everything in this Troubleshooting Table before you bring the sprayer to a Graco/Magnum authorized service center. Refer to Component Identification, page 6 for reference letters used in table.
Problem | Cause | Solution |
|
|
|
|
|
|
Power switch is on and sprayer is | Pressure is set at zero pressure. | Turn Pressure Control Knob (C) |
plugged in, but motor does not run, |
| clockwise to increase pressure set- |
and pump does not cycle. |
| ting. |
|
|
|
| Motor or control is damaged. | Take sprayer to Graco/magnum |
|
| authorized service center. |
|
|
|
| Electric outlet is not providing power. | • Try a different outlet or plug in |
|
| something that you know is work- |
|
| ing to test outlet. |
|
| • Reset building circuit breaker or |
|
| replace fuse. |
|
|
|
| Extension cord is damaged. | Replace extension cord. Read |
|
| Grounding and Electric Require- |
|
| ments, page 5. |
|
|
|
| Sprayer electric cord is damaged. | Check for broken insulation or wires. |
|
| Replace electric cord if damaged. |
|
|
|
Power switch is on and sprayer is | Paint is frozen or hardened in pump. | Unplug sprayer from outlet. If frozen |
plugged in, but motor does not run, |
| do NOT try to start sprayer until it is |
and pump does not cycle. |
| completely thawed or you may dam- |
|
| age the motor, control board and/or |
|
| drivetrain. |
|
| Make sure power switch is OFF. |
|
| Place sprayer in a warm area for sev- |
|
| eral hours. Then plug in and turn ON. |
|
| Slowly increase pressure setting to |
|
| see if motor will start. |
|
| If paint is hardened in sprayer, pump |
|
| packings, valves, drivetrain or pres- |
|
| sure switch may need to be replaced. |
|
| Take sprayer to Graco/magnum |
|
| authorized service center. |
|
|
|
22 | 309225W |
