Grandstream Networks, Inc. |
To make a direct IP call, first pick up the analog phone or turn on the speakerphone on the analog phone, then access the voice menu prompt by dial “***” or press the button on the
Examples:
If the target IP address is 192.168.0.10, the dialing convention is
Voice Prompt with option 47, then 192 168 000 010
followed by pressing the “#” key if it is configured as a send key or wait for more than 5 seconds.
If the target IP address/port is 192.168.1.20:5062, then the dialing convention would be:
Voice Prompt with option 47, then 192168001020*45062 followed by pressing the “#” key if it is configured as a send key or wait for 4 seconds.
NOTE:
•When doing direct IP call, the “Use Random Port” should set to “NO”.
•You can NOT make direct IP calls between FXS1 to FXS2 since they are using same IP.
5.2.3Call Hold
While in conversation, pressing the “flash” button on the attached analogue phone (if the phone has that button) will put the remote end on hold. Pressing the “flash” button again will release the previously held party and the
5.2.4Call Waiting
If call waiting feature is enabled, while the user is in a conversation, he will hear a special stutter tone if there is another incoming call. User can press the flash button to put the current call party on hold and switch to the other call. Pressing flash button toggles between two active calls.
5.2.5Call Transfer
5.2.5.1 Blind Transfer
Assume that call party A and B are in conversation. A wants to Blind Transfer B to C:
1.A press FLASH on the analog phone to hear the dial tone.
2.Then A dials *87 then dials C’s number, and then #(or wait for 4 seconds)
3.A can hang up.
NOTE:
12
