Grizzly G0526 instruction manual Belt, To install the V-belt

V-Belt

Components and Hardware Needed: Qty
V-Belt A-54	1
Tools Needed:
12mm Wrench or Socket	1
Straightedge	1
To install the V-belt:

1.Remove the back access panel from the join- ter stand.

2.Using a 12mm wrench, loosen the motor mount bolts. NoteÑDO NOT completely remove the motor mount bolts.

3.Slide the motor upward far enough to allow the V-belt to be placed around the cutterhead pulley and the motor pulley.

4.Carefully allow the motor to slide downward, tensioning the V-belt with the weight of the motor.

5.Using a straightedge, check the alignment of the V-belt and the two pulleys (Figure 14).

Figure 14. The V-belt should be in alignment

with the two pulleys.

ÑIf the V-belt is aligned between the pul- leys, continue on to step 7.

ÑIf the V-belt is NOT aligned between the pulleys, continue with the next step.

6.Adjust the motor until the V-belt is aligned between the pulleys. NoteÑThe pulleys can also be adjusted in and out along the motor shaft and cutterhead shaft by loosening the pulley setscrews.

7.Tighten the motor mount bolts loosened in step 1

G0526 6" Jointer -17-