Grizzly G0526 instruction manual Cutterhead Guard Belt Guard, To install the cutterhead guard

Cutterhead Guard V-Belt Guard

Components and Hardware Needed: Qty
Cutterhead Guard	1
Tools Needed:
2.5mm Allen Wrench	1
To install the cutterhead guard:

1.Slide the cutterhead guard shaft down through the mounting hole on the table. NoteÑThe guard may not fully seat in the hole initially; however, rotating the guard will allow the shaft to fully seat in the hole.

2.Using a 2.5mm Allen wrench, thread the setscrew through the hole in the forked end of the cutterhead guard shaft (Figure 17). NoteÑThread the setscrew far enough to prevent the guard from being pulled out.

Figure 17. Cutterhead guard setscrew.

3.Raise the fence and rotate the guard one revolution counter-clockwise as it appears from the top. Hold the guard in position.

4.Lower the fence and allow the guard to swing back against the fence.

NOTICE

The cutterhead guard must always return to the closed position whenever it is moved. Repeat steps 1-3 until this occurs.

Components and Hardware Needed: Qty
V-Belt Guard	1
Hex Bolt 5Ú16"-18 x 21Ú2"	1
Flat Washer 5Ú16"	1
Tools Needed:
12mm Wrench or Socket	1
To install the V-belt guard:

Using a 12mm wrench, secure the V-belt guard over the cutterhead pulley and V-belt with the hex bolt and flat washer (Figure 18).

V-Belt Guard

Figure 18. Correctly installed V-belt guard.

G0526 6" Jointer -19-