Dust Port |
| Fence |
|
|
|
|
|
|
Components and Hardware Needed: Qty | |
Dust Port | 1 |
Phillips Screws | 4 |
Flat Washers 1Ú4" | 4 |
Tools Needed: |
|
Phillips Head Screwdriver | 1 |
To install the dust port: |
|
Using a Phillips head screwdriver, secure the dust port to the dust chute opening with the Phillips screws and flat washers (Figure 15). NoteÑMake sure the dust port hose
Figure 15. Correctly installed dust port.
Components and Hardware Needed: Qty | |
Fence Assembly | 1 |
Lock Handle | 1 |
Special Nut | 1 |
Flat Washer 1Ú2" | 1 |
Tilt Lever W/Knob | 1 |
To attach the fence assembly: |
|
1.Place the fence assembly on the jointer as it was before removing it for cleaning (see page 15), making sure the key and keyways align with one another.
2.Secure the fence assembly to the jointer with the lock handle, the flat washer, and the spe- cial nut (Figure 16). NoteÑMake sure the flanges on the special nut protrude upward and into the slot on the underside of the fence support.
Tilt Lever
Threading
Location
Figure 16. Correctly installed fence assembly.
3.Thread the tilt lever into the fence casting.
G0526 6" Jointer |
