Pedestal Switch

 

Handwheels

 

 

 

 

 

 

Components and Hardware Needed: Qty

Pedestal Switch

1

Hex Bolts 5Ú16"-18 x 1"

4

Hex Nuts 5Ú16"-18

4

Flat Washers 5Ú16"

8

Tools Needed:

 

12mm Wrench or Socket

2

To install the pedestal switch:

 

Using two 12mm wrenches, secure the pedestal switch to the jointer stand with the hex bolts, the flat washers, and the hex nuts (Figure 19).

Figure 19. Correctly installed pedestal switch.

Components and Hardware Needed: Qty

Handwheels

2

Handwheel Handles

2

Tools Needed:

 

Phillips Head Screwdriver

1

14mm Wrench

1

To install the handwheels:

 

1.Using a 14mm wrench, secure the hand- wheel handles to the handwheels (Figure 20).

Figure 20. Securing the handwheel handle.

2.Using a Phillips head screwdriver, remove the two Phillips head screws and flat wash- ers from the end of the leadscrews under each table.

3.Secure the handwheel assemblies to the end of the leadscrews with the Phillips head screws and flat washers that were removed in step 2.

-20-

G0526 6" Jointer

Page 22
Image 22
Grizzly G0526 instruction manual Pedestal Switch Handwheels, To install the pedestal switch, To install the handwheels