Grizzly G0526 instruction manual BeltsLubrication, Carbide Cutters

V-BeltsLubrication

To ensure optimum power transmission from the motor to the blade, the V-belt must be in good condition (free from cracks, fraying and wear). Check the V-belt at least every 3 months; more often if the jointer is used daily.

Carbide Cutters

The carbide cutters are typically rotated at the same time when they become dull; however, the cutters can also be rotated individually when one becomes nicked or damaged. Refer to Section 8: Service Adjustments for instructions on rotating or replacing the carbide cutters.

Since all bearings are sealed and permanently lubricated, simply leave them alone until they need to be replaced. DO NOT lubricate them.

Table ways and the fence assembly should not be lubricated. If the tables appear to be stuck, dis- assemble and clean any foreign materials from the ways. Re-assemble and reset the gibs.

G0526 6" Jointer -29-