Grizzly G0526 instruction manual Service Adjustments, About Service, Outfeed Table Height

SECTION 8: SERVICE ADJUSTMENTS

!	Always	disconnect
	power	to the machine
	before	performing ser-
	vice adjustments. Failure
	to do this may result in
	serious personal injury.

About Service

This section is designed to help the operator with adjustments that were made at the factory and that might also need to be made during the life of the machine.

This section is provided for your convenienceÑit is not a substitute for the Grizzly Service Department. If any adjustments arise that are not described in this manual, then feel free to call the Grizzly Service Department at (570) 546-9663.

Similarly, if you are unsure of how to perform any procedure in this section, the Grizzly Service Department will be happy to guide you through the procedures or help in any other way.

Outfeed Table

Height

The outfeed table must be level with the carbide cutters when they are at top-dead-center.

To set the outfeed table height:

1.Place a straightedge on the outfeed table so it extends over the cutterhead.

2.Rotate the cutterhead pulley until one of the carbide cutters is at top-dead-center.

3.Raise or lower the outfeed table until the car- bide cutter just touches the straightedge (Figure 28).

Figure 28. Setting the outfeed table height.

G0526 6" Jointer -31-