Grizzly G0605X Riving Knife, On/Off Switch, To install the riving knife, To install the switch

5.Slide the bracket screws shown in Figure 28 into the notches on the splitter, push the guard forward, and tighten the lock knob (Figure 29).

Note: Make sure the clear plastic flap is pushed toward the inside of the guard.

Screws

Notches

Figure 28. Installing blade guard on splitter.

Lock knob

Cover

Flap

Figure 29. Blade guard installed.

6.Swing the covers down to guard the blade.

Riving Knife

You MUST install the riving knife or the splitter and blade guard before operating the table saw.

Components and Hardware Needed:	Qty
Riving Knife	1
To install the riving knife:

1.Remove the table insert, blade guard, and splitter—if previously installed.

2.Lift the lever (Figure 30), insert the riving knife into the bracket slot, and turn the lever down to secure the knife.

3.Reinstall and secure the table insert.

Riving Knife

Bracket

Lever

Figure 30. Riving knife installed.
On/Off Switch
Components and Hardware Needed:	Qty
Safety Pin	1
Flange Bolts M8-1.25 x 25	2
To install the switch:

1.Fasten the switch to the left end of the front rail with two flange bolts, and install the anti- start safety pin as shown in Figure 31.

-24- G0605X/G0606X Extreme Series 12" Table Saw