Blade Tilt Stops

The table saw features stop bolts that stop the blade exactly at 45° and 90° during blade adjust- ments. The stops have been set at the factory and should require no adjustments. However, we still recommend that you verify the settings.

Tools Needed

Qty

90° Square

1

Combo Square

1

Wrench 12mm

1

Hex Wrench 4mm

1

Hex Wrench 5mm

1

To set the 90° stop bolt:

 

1.DISCONNECT THE SAW FROM POWER!

2.Position the blade tilt to zero (see indicator on the front of the saw), and raise the blade several inches above the table.

3.Place a machinist’s square against the table and blade so it contacts the blade evenly from bottom to top. Make sure a blade tooth does not obstruct the movement of the square.

—If the blade is 90° to the table when the stop bolt contacts the underside of the table, go to To Set the 45° Stop Bolt.

—If the blade is not 90° to the table, you will need to adjust the 90° stop bolt.

4.Tilt the blade to 20° to access the 90° stop bolt under the table.

5.Open the motor access cover, loosen the jam nut shown in Figures 75 & 76, adjust the stop bolt up or down, and repeat Steps 2-3until the stop bolt contacts the table when the blade is at 0°.

G0605X/G0606X Extreme Series 12" Table Saw

90° Stop Bolt

& Jam Nut

Figure 75. 90° stop bolt and jam nut.

90° Stop Bolt

& Jam Nut

Figure 76. 90° stop bolt and jam nut (table

removed for clarity).

6.Tighten the jam nut.

To set the 45° stop bolt:

1.Repeat Steps 1-3from the previous set of steps using a combo square set to 45°.

—If the blade is 45° to the table when the stop bolt contacts the cabinet, go to To Adjust the Tilt Indicator Arrow.

—If the blade is not 45° to the table go to Step 2.

2.Remove the blade height lock knob and handwheel.

3.Move the blade angle to 30°, or remove the panel on the right side of the cabinet to access the 45° stop bolt.

-49-

Page 51
Image 51
Grizzly G0606X, G0605X owner manual Blade Tilt Stops, To set the 90 stop bolt, To set the 45 stop bolt