Grizzly G0606X, G0605X owner manual Fence Components, Miter Gauge, To install the miter gauge

Flange Bolt

Stop Paddle

Fence Components

Components and Hardware Needed:	Qty
Fence Knob	1
Fence Resting Brackets	2
Flange Bolts M8-1.25 x 12	2

Anti-Start
Safety Pin
Figure 31. Switch installed.
Miter Gauge
Components and Hardware Needed:	Qty
Miter Gauge	1
Miter Gauge Handle	1
Flat Washer 8mm	1
To install the miter gauge:

1.Install the miter gauge handle and 8mm flat washer onto the miter gauge as shown in Figure 32.

Handle

Washer

Figure 32. Miter gauge installed.

2.Slide the miter gauge into the miter gauge slot to the left of the blade; or store it tempo- rarily on the brackets near the blade angle handwheel.

G0605X/G0606X Extreme Series 12" Table Saw

To install the fence knobs, fence, and fence resting brackets:

1.Install the fence knob as shown in Figure 33.

Figure 33. Fence knob installed.

2.Install the fence onto the table to the right of the blade.

3.Install the fence resting brackets (Figure 34) onto the cabinet under the Outfeed Table with two flange bolts.

Brackets

Figure 34. Fence resting brackets installed.

-25-