3.Place the extension table assembly upright with the feet on the ground, align the slots in the extension table bracket with the rear rail mounting holes, then fasten the table to the rail with two
Flange Bolts
Bracket
Figure 22. Outfeed table fastened to rear rail.
4.Secure the lower shelf brackets to the sup- port legs and cabinet with four M6-1 x 12 hex bolts, four flat washers and two hex nuts.
5.Install the lower shelf on the brackets.
6.Place the fence tube over the front rail and secure with nine M8-1.25 x 12 flange bolts as shown in Figure 23.
Flange Bolt
Figure 23. Fence tube mounted to front fence
rail.
Saw Blade
The saw blade is extremely sharp. Use extra care when handling the blade or working near it. Serious injury is possible.
Review this section, even if your saw blade came
To install the blade:
1.DISCONNECT THE SAW FROM POWER!
2.Push a piece of scrap wood against the blade to prevent the blade from rotating, then use the arbor wrench to loosen the arbor nut.
Note: The arbor nut has right hand threads; turn it counterclockwise to loosen.
3.Remove the arbor nut and the outer arbor flange.
4.Slide the blade over the arbor with the teeth facing the front of the saw as shown in Figure 24.
Teeth Direction |
& Blade Rotation |
Front Of Saw |
Figure 24. Correct blade direction.
5.Re-install the arbor flange and the arbor nut, and tighten them against the blade with the wrench included with the saw. DO NOT over- tighten.
G0605X/G0606X Extreme Series 12" Table Saw |
