Table Insert
You MUST install the table insert before operating the table saw.
Components and Hardware Needed: | Qty |
Table Insert | 1 |
Flat Head Screw | 1 |
To install and adjust the table insert: |
|
1.DISCONNECT THE SAW FROM POWER!
2.Place the table insert into the table and tight- en the screw shown in Figure 25.
Table Insert
Screw
Figure 25. Table insert screw.
3.Place a straightedge across the table and the table insert.
4.Use a 3mm hex wrench and straightedge to adjust the table insert flush with the table as shown in Figure 26.
NOTICE: The table insert must be flush with the table top or the workpiece will hit the edge of the table insert at the beginning of the cut.
Blade Guard and
Splitter
You MUST install the blade guard and splitter before operating the table saw.
Components and Hardware Needed: | Qty |
Splitter | 1 |
Blade Guard | 1 |
To install the blade guard:
1.DISCONNECT THE SAW FROM POWER!
2.Raise the blade up all the way, unscrew the screw on the table insert, and remove the insert.
3.Lift the lever shown in Figure 27, insert the splitter into the bracket slot, and turn the lever down to lock the splitter.
Splitter |
Bracket |
Lever |
Figure 27. Splitter installed.
4.Reinstall the table insert and secure it with the screw removed in Step 2.
Figure 26. Adjusting the table insert.
G0605X/G0606X Extreme Series 12" Table Saw |
