Attaching the Fence
Support
Components and Hardware Needed: | Qty |
Jointer Bed Assembly | 1 |
Fence Support | 1 |
Locking Plate Assembly | 1 |
Fence Sliding Handle | 1 |
Cap Screws | 2 |
Lock Washers 8mm | 2 |
Hex Wrench 6mm | 1 |
To attach the fence support: |
|
1.DISCONNECT THE JOINTER FROM POWER SOURCE!
2.Use two cap screws and lock washers to attach the fence support to the jointer bed as shown in Figure 9.
Cap Screws
3.Insert the locking plate assembly into the fence support, positioning it so the two pins are against the bottom edge of the fence sup- port as shown in Figure 10.
Locking Plate
Assembly
Locking
Plate Pins