Grizzly G0612 owner manual Test Run, Attaching the dust collection bag

2.Slip the bag clamp over the collection bag, then attach the collection bag to the chute and clamp it as shown in Figure 20.

Bag

Clamp

Figure 20. Attaching the dust collection bag.

Test Run

Before you begin operations, do Steps 1-7below to make sure your jointer is running properly.

Loose hair and cloth- ing could get caught in machinery and cause serious personal inju- ry. Keep loose clothing rolled up and long hair tied up and away from machinery.

Projectiles thrown from the machine could cause serious eye injury. Wear safety glasses during assembly and operation.

To test run your jointer:

1.Read the entire instruction manual first!

-16-

2.Make sure the cutterhead guard fully covers the cutterhead.

3.Make sure all tools and foreign objects have been removed from the machine.

4.Review SECTIONS 1 and 2 (SAFETY and CIRCUIT REQUIREMENTS) on Pages 5- 8 and connect your machine to the power source.

5.Turn the jointer ON.

—The jointer should run smoothly with little or no vibration.

—Immediately stop the jointer if you suspect any problems. Refer to Pages 31 & 32 to troubleshoot and fix any problems before starting the jointer again.

6.Turn the jointer OFF, then remove the safety key from the ON/OFF paddle switch.

7.Lift the paddle switch to the ON position.

—If the jointer motor does not start, then the safety key is working properly and you have finished the test run.

—If the jointer motor starts when the safety key is removed, IMMEDIATELY DISCONNECT THE JOINTER FROM THE POWER SOURCE. Refer to Pages 32 & 33 to troubleshoot the problem.

—If you still cannot solve this or any other problem that arises during the test run, call Grizzly Tech Support at (570) 546-9663.

G0612 6" Jointer