![](/images/new-backgrounds/1240557/24055775x1.webp)
SECTION 6: MAINTENANCE
Always disconnect power to the machine before performing maintenance. Failure to do this may result in serious person- al injury.
Schedule
For optimum performance from your machine, follow this maintenance schedule and refer to any specific instructions given in this section.
Daily Check:
•Loose mounting bolts.
•Damaged centers or faceplate.
•Worn or damaged wires.
•Any other unsafe condition.
Weekly Maintenance:
•Clean off dust buildup.
•Clean and lubricate lathe bed, spindle, and quill.
Monthly Check:
•Belt tension, damage, or wear.
•Clean out dust buildup from inside belt/pulley cavity.
Cleaning
Lathe Bed
Protect the unpainted cast iron lathe bed by wip- ing it clean after every
Keep your lathe bed
Lubrication
All bearings for the Model G0632 are lubricated and sealed at the factory, and do not need addi- tional lubrication.
Wipe a lightly oiled shop rag on the outside of the headstock spindle. DO NOT allow any oil to get on the inside mating surfaces of the spindle.
Use the tailstock handwheel to extend the quill out to the furthest position and apply a thin coat of white grease to the outside of the quill. DO NOT allow any oil or grease to get on the inside mating surfaces of the quill.
Cleaning the Model G0632 is relatively easy. Vacuum excess wood chips and sawdust, and wipe off the remaining dust with a dry cloth. If any resin has built up, use a resin dissolving cleaner to remove it.
Treat all unpainted cast iron and steel with a non- staining lubricant after cleaning.
Remove and debris or oily substances from the inside of the spindle and quill.
G0632 16" x 42" Variable Speed Wood Lathe |