Grizzly G0656 owner manual Assembly, To assemble the jointer

Assembly

To assemble the jointer:

1.Carefully lay the stand on its side so you can access the underside.

2.Bolt the wheel assembly to the stand with the provided hardware, as shown in Figure 7.

Note: Refer to the Inventory List on Page 11 for a list of components needed for ass- sembly.

Hex Bolt M8-1.25 x 50

Flat Washer 8mm

Hex Bolts M10-1.5 x 55

Flat Washers 10mm

Hex Nuts

M10-1.5

Figure 7. Example of bolting the wheel assembly

to the stand.

3.Turn the stand rightside up.

The jointer is heavy. Seek assistance when lifting it onto the jointer stand.

4.Remove the rear access panel from the jointer stand.

-14-

5.With the help of an assistant, lift the jointer onto the stand.

6.Align the mounting holes on the jointer and stand.

7.Secure the jointer to the stand with the M8- 1.25 x 50 cap screws, washers, and hex nuts, as shown in Figure 8.

�������	����������
	������������

���������������

���������������

����� ���������������

���������������

Figure 8. Jointer secured to stand.

8.Using a 13mm wrench, loosen the motor bracket fasteners shown in Figure 9.

Note: DO NOT completely remove the motor mount bolts.

Figure 9. Motor bracket fasteners (black

arrows); motor mount fasteners (white arrows).

G0656 8" Jointer with Built-In Mobile Base