To surface plane on the jointer:
1.Read and understand SECTION 1: SAFETY, beginning on Page 6.
2.Make sure your stock has been inspected for dangerous conditions as described in the Stock Inspection & Requirements instruc- tions, beginning on Page 21.
3.Set the cutting depth for your operation. (We suggest 1⁄32" for surface planing, using a more shallow depth for hard wood species or for wide stock.)
4.Make sure your fence is set to 90˚.
5.If your workpiece is cupped (warped), place it so the concave side is face down on the surface of the infeed table.
6.Start the jointer.
Failure to use push blocks when surface planing may result in cutterhead contact, which will cause serious personal injury. Always use push blocks to protect your hands when surface planing on the jointer.
7.With a push block in each hand, press the workpiece against the table and fence with firm pressure, and feed the workpiece over the cutterhead.
Note: If your leading hand (with push block) gets within 4" of the cutterhead, lift it up and over the cutterhead, and place the push block on the portion of the workpiece that is on the outfeed table. Now, focus your pres- sure on the outfeed end of the workpiece while feeding, and repeat the same action with your trailing hand when it gets within 4" of the cutterhead. To keep your hands safe, DO NOT let them get closer than 4" from the cutterhead when it is moving!
8.Repeat Step 7 until the entire surface is flat.
G0656 8" Jointer with Built-In Mobile Base
Edge Jointing
The purpose of edge jointing is to produce a fin- ished,
NOTICE
If you are not experienced with a jointer, set the depth of cut to 0", and practice feeding the workpiece across the tables as described below. This procedure will better prepare you for the actual operation.
