Grizzly G1012 instruction manual Order of Assembly, Stand

SECTION 4: ASSEMBLY

Keep loose clothing out of the way of machinery and keep hair pulled back, or serious injury may occur.

Disconnect power to the machine when perform- ing any maintenance or assembly. Failure to do this may result in serious personal injury.

Wear safety glasses dur- ing the entire assembly process. Failure to com- ply may result in serious personal injury.

Order of Assembly

We have organized the assembly process of the Model G1012 into steps listed below. Please fol- low them in sequence. The inventory photos and lists, hardware recognition chart, parts list and exploded diagram have been provided to make assembly as easy as possible.

1.Stand

2.Motor

3.Mounting Unit to Stand

4.Wiring

5.Pulley Alignment

6.Table

7.Fence Assembly

8.Total Unit Check

NOTICE

TOOLS REQUIRED: In addition to the tools provided with your bandsaw, you will need a metric set of wrenches, large and medium flat-tipped screwdrivers, a Phillips® screw- driver, and a 6" or 8" adjustable wrench.

Stand

To begin the stand assembly, locate all the stand parts so they are within easy reach.

1.Flip the stand top upside down. Install the two adjustment bolts on the stand top by placing the 3⁄8"-16 x 11⁄4" carriage bolts through the mounts on the stand top and then the through eyes of the adjustment bolts. Secure with 3⁄8" washers and hex nuts, but do not completely tighten.

2.Using (2) 3⁄8"-16 x 3⁄4" carriage bolts, wash- ers, and hex nuts; attach the motor bracket to the mounts on the stand top without tight- ening.

3.Place a 3⁄8"-16 hex nut and washer on each adjustment bolt, then rotate the motor brack- et over the adjustment bolts, and secure with another 3⁄8"-16 hex nut and washer so your assembly looks like Figure 5. Again, do not completely tighten at this time.

-12- G1012 18" Bandsaw