6.To tighten the belt from the stepped pulley to the motor, loosen the nuts on each motor adjustment bolt and lower the motor into position. The weight of the motor is sufficient for the amount of tension required. Tighten the nuts against the motor plate, so your assembly looks similar to Figure 17.
Figure 17. V-belts mounted on pulleys.
Belt Guard
1.When all belts are installed, aligned, and tightened, fasten the last stand side to the stand legs. (If this has already been done, skip this step.)
2.Place the belt cover over the pulleys on the bandsaw unit and secure with the (2)
Figure 18. Belt cover mounted to stand.
DO NOT operate bandsaw with cover removed or serious personal injury may occur!
|
|
|
|
|
|
|
|
|
|
|
|
G1012 18" Bandsaw | |||
