SECTION 5: ADJUSTMENTS
Keep clothing rolled up and out of the way of machinery and keep hair pulled back.
Disconnect power to the machine when perform- ing any maintenance or assembly. Failure to do this may result in serious personal injury.
Wear safety glasses dur- ing the entire adjustment process. Failure to com- ply may result in serious personal injury.
Location Of Controls
General control and adjustment locations are shown in Figure 23 and are described below.
A
E
C
A
D
B 
Figure 23. Location of controls.
A. These two knobs secure the upper and lower wheel covers. The covers are only opened to change a blade or make an adjustment to blade tracking.
B. This is the push button switch that controls the power to the motor.
C. This knob locks the rip fence in position.
D. These trunnion knobs are used to lock the table in position.
E.The miter gauge slides in the milled groove in the table and can be set at any angle between 45° left and 45° right. Use the miter gauge for crosscutting and miter-cut- ting.
G1019 14'' Bandsaw |
