5.Install the table taper pin and table insert.
6.Install the blade guard.
7.Close the top and bottom covers.
Gullet |
|
| Tooth |
Tooth |
|
| Gullet |
Gullet Line | Blade Set |
|
Figure 31. Side and front views of a standard
bandsaw blade.
The bandsaw blade is dangerously sharp. Use extreme caution when working near the saw blade. Failure to exercise care could result in severe injury.
Ripping
Ripping is the process of cutting a board into two or more thinner boards, generally in a direction along its length. The maximum board width that can be ripped is limited by the distance between the blade and the support column. Maximum cut- ting width for this bandsaw is 131⁄2".
Blade selection is an important consideration when ripping. Generally, the wider the blade, the better. In most applications, a hook or skip tooth style will be sufficient. Also, since most ripped lumber will be planed or sanded smooth, you can choose blades with fewer
Be aware that blade lead is an inherent situation with all bandsaws during ripping operations that involve using the fence. Consult with the “Blade Lead” instructions on why this happens and what you can do about it.
To perform ripping operations:
1.The bandsaw must be adjusted correctly. See “Blade Tension/Tracking” instructions.
2.The table must be square to the blade. See “Table Adjustment” instructions.
3.Use the widest blade available. The blade must also be in good condition.
4.Use a fence to guide work.
5.Draw a reference line on the edge of the board.
6.Support ends of the board if necessary.
7.Feed work slowly and evenly.
G1019 14'' Bandsaw |
