To tilt the table to the left:
1.Loosen the two trunnion knobs below the table trunnions.
2.Tilt the table to the right enough to gain clearance to the positive stop bolt. Loosen the lock nut, then remove the positive stop bolt.
3.The table will now tilt left to approximately 10°.
4.When the left tilt operation is complete, rein- stall the positive stop bolt.
To adjust the positive stop so the table will be per- pendicular (90°) to the blade:
1.Loosen two trunnion knobs and the locknut securing the positive stop adjusting bolt.
2.Raise the upper blade guide assembly and place a 6" adjustable square or
3.Secure the trunnion knobs and lock the pos- itive adjusting bolt by tightening the locknut. Ensure that the bolt does not turn while tightening the locknut. Set the angle pointer to zero for future reference.
Figure 29. Squaring table to blade.
The table can be shifted side to side to properly align the miter slot and the blade:
1.Loosen the 6 trunnion bolts underneath the table.
2.Install the largest width blade available in the machine. Lay a straightedge along side the blade and inspect it closely to make sure it is parallel to the blade.
Make sure the straightedge doesn’t deflect the blade. Measure the distance between the edge of the miter gauge slot and the straightedge at points A and B.
G1019 14'' Bandsaw |
