Hach 6120118 user manual Canadian Interference-causing Equipment Regulation, IECS-003, Class A

Models: 6120118

1 52
Download 52 pages 56.45 Kb
Page 44
Image 44
Compliance Information

Compliance Information

Canadian Interference-causing Equipment Regulation, IECS-003, Class A

Supporting test records by Hewlett Packard, Fort Collins, Colorado Hardware Test Center (A2LA # 0905-01) and certified compliance by Hach Company.

This Class A digital apparatus meets all requirements of the Canadian Interference- Causing Equipment Regulations.

Cet appareil numèrique de la classe A respecte toutes les exigences du Rëglement sur le matÈriel brouilleur du Canada.

FCC PART 15, Class “A” Limits

Supporting test records by Hewlett Packard, Fort Collins, Colorado Hardware Test Center (A2LA # 0905-01) and certified compliance by Hach Company.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his own expense. The following techniques of reducing the interference problems are applied easily.

1.Disconnect the Controller from its power source to verify that it is or is not the source of the interference.

2.If the Controller is connected into the same outlet as the device with which it is interfering, try another outlet.

3.Move the Controller away from the device receiving the interference.

4.Reposition the receiving antenna for the device receiving the interference.

5.Try combinations of the above.

44

Page 44
Image 44
Hach 6120118 Canadian Interference-causing Equipment Regulation, IECS-003, Class A, FCC PART 15, Class “A” Limits