User Interface and Navigation
4.1.1 Controller Display Features
When a sensor is connected and the controller is in measurement mode, the controller automatically identifies the connected sensors and displays associated measurements.
The display will flash on startup, when a sensor error has occurred, and when a sensor is being calibrated.
An active system warning will cause the warning icon (a triangle with an exclamation point inside) to be displayed on the right side of the display. See Figure 13.
Figure 13 | Display |
1 
SENSOR NAME:
2 
7.00 pH 
3 
TEMP: 23.0°C
4
5
6
1. | Status bar. Indicates the sensor name and status of relays. The relay | 4. | Parameter |
| letter is displayed when the relay is energized. |
|
|
|
|
|
|
2. | Main measurement | 5. | Warning icon area |
|
|
|
|
3. | Secondary measurement (if applicable) | 6. | Measurement units |
|
|
|
|
4.1.2Important Key Presses
•Press HOME then the RIGHT or LEFT key to display two readings when two sensors are connected. Continue to press the RIGHT or LEFT key to toggle through the available display options as shown below.
•Press the UP and DOWN keys to toggle the status bar at the bottom of the measurement display to display the secondary measurement (temperature) and output information.
SENSOR NAME:
pH
7.00 pH
TEMP: 23.0°C
SENSOR NAME:
pH
7.00 pH
OUTPUT1: 12.00 mA
SENSOR NAME:
pH
7.00 pH
OUTPUT2: 12.00 mV
•When in Menu mode, an arrow may appear on the right side of the display to indicate that more menus are available. Press the UP or DOWN key (corresponding to the arrow direction) to display additional menus.
MAIN MENU
SENSOR DIAG 
SENSOR SETUP
SYSTEM SETUP
TEST/MAINT
SYSTEM SETUP
OUTPUT SETUP
RELAY SETUP 
NETWORK SETUP
DISPLAY SETUP
SYSTEM SETUP
DISPLAY SETUP
SECURITY SETUP 
LOG SETUP
CALCULATION
SYSTEM SETUP
SECURITY SETUP
LOG SETUP 
CALCULATION
ERROR HOLD MODE
20
