Haier CWH18A, CWH12A, CWH24A manual Starting Your Air Conditioner, Cool Only Models

AIR CONDITIONER USE

Operating your air conditioner properly helps you to obtain the best possible results.

This section explains proper air conditioner operation.

IMPORTANT:

■If you turn off the air conditioner, wait at least 3 minutes before turning it back on. This prevents the air conditioner from blowing a fuse or tripping a circuit breaker.

■Do not try to operate your air conditioner in the Cool mode when outside temperature is below 65°F (18°C). The inside evaporator coil will freeze up, and the air conditioner will not operate properly.

NOTE: In the event of a power failure, your air conditioner will operate at the previous settings when the power is restored.

Starting Your Air Conditioner

Cool Only Models

ENERGY STAR

	Heat/Cool Models
AUTO	AUTO
+	+

		LOW				LOW	TEMP
			TEMP
		MED	_			MED	_
FILTER	FAN			FILTER	FAN
MONITOR	SPEED	HIGH		MONITOR	SPEED	HIGH

		TIMER			HEAT TIMER
POWER	COOL DRY	FAN POWER	POWER	COOL DRY	FAN POWER
	MODE	SAVER		MODE	SAVER

NOTE: When the air conditioner is set to Fan mode and the room temperature is below 32°F (0°C), the display will show LO. If the room temperature is above 99°F (37°C), the display will show HI.

1.Remove the clear protective film from the front panel badge.

2.Press the power button to turn on the air conditioner.

NOTE: When the air conditioner is turned on for the first time after it is plugged in, the display will show the current room temperature and will run in the Smar System control .

When the air conditioner is turned on at all other times, the display will show the previous settings for 5 seconds, and then show the current room temperature.

3.Select mode. See "Moode".

4.Select fan speed. See "Fan Speed".

5.Set temperature. See "Temperature".

Mode

1.Press MODE until you see the indicator light glow for the desired setting.

2.Choose Cool, Dry, Fan or Heat (Heat/Cool models only).

■Cool– Cools the room. Press FAN SPEED to select High, Med, Low or Auto. Press the plus or minus TEMP button to adjust the temperature.

■Dry--Dries the room. The air conditioner automatically selects the temperature. Fan runs on Low speed only.

NOTE: Dry mode should not be used to cool the room.

■Fan– Only the fan runs. Press FAN SPEED to select High, Med or Low. The display shows the current room temperature.

NOTE: Auto fan speed cannot be selected in Fan mode.

■Heat (Heat/Cool models only)--Heats the room. Press FAN SPEED to select High, Med, Low or Auto. Press the plus or minus TEMP buttons to adjust the temperature.

■Power saver--The fan will run at low speed when compressor turn off resporse to set tempreture,when the compressor cycles back on,the fan will reture to the set fan speed.

NOTE: Because the fan does not circulate the room air at high speed,less energy is used.

HEAT

COOL DRY FAN POWER

SAVER

NOTE: After 5 seconds, the display will show the current room temperature.

12