Removing and Installing the Ice Container
Removing the Ice Container | Reinstall the Ice Container |
Take down food in the ice cream shelf. Raise the center of the container away from the shelf frame, hold down the front, and pull the container out.
Reinstall the ice container and fix the clamp in the lower right side into the groove on the back wall. If the ice container cannot be fully inserted, remove it and turn the driving device in a 1/4 circle. Try to reinstall the ice container. Repeat until the clamp can be fixed in the groove on the two slide ways of the shelf.
Rotate
Driving
Device
Precautions When Using the Ice Maker and Cold Water Dispenser
Do not use a cup that is too deep, too narrow, or too soft.
Keep the cup a proper distance from the dispenser. Raise the cup near the ice outlet to prevent and ice cube jumping or splashing out. If the cup is to close, the ice might break when it hits the bottom. 5 seconds after you take ice, you will here a sound. This is the sound of the ice chute door closing.
After you take ice and release the lever, keep your cup in the ice outlet for 2 - 3 seconds, as cubed ice might still come out.
After you take water, keep your cup under the dispenser for 2 - 3 seconds, as water might still come out.
Do not pour extra water into the spill shelf. Wipe water dripped form the drink dispenser with a cloth.
If you choose cubed ice right after crushed ice, you may get some crushed ice mixed in.
If you only use crushed ice, the outlet may become blocked by crushed ice. Remove the remaining crushed ice to continue using.
Do not put a drink bottle or other food in the ice container for fast cooling. This could damage the ice maker.
Do not touch the ice outlet by hand - it may cause injury to your hand. Do not dismantle the ice maker cover.
Throw out the first 7 glasses of water and 20 ice cubes to flush out impurities in the pipe. Throw away the first several batches of ice cubes after a long period of non use.
Do not put purchased cubed ice in the ice container. It may not crush or dispense well.
If cubed ice is too small, it means the inlet water amount is too small. If cubed ice is too big, or there is a water overflow in the ice maker that causes ice blocks to occur, the inlet water amount is too big. Ice tray fill adjustments can be made on the Freezer control by pressing the (<) and (>) buttons for 3 seconds until you hear a chime. The display will read the default setting of 40 (for 4 second water flow in). If you press the (>) button it can raise up flow rate to 60 (a max of 6 second fill rate). Check water tray level to not over fill the ice tray.
When you are making cubed ice, the water valve will make a noise. This is normal. Note
20
