Using the Ice Maker and Cold Water Dispenser
Working Principle
The ice content will depend on room temperature, door openings, water pressure, freezer temperature, etc. It is considered normal when ice cubes stick together.
Note
Wait 24 hours after installing your refrigerator before you begin using the ice maker feature. This gives the ice maker time to load the ice bucket.
If This is Your First Ice Maker
Occasionally you may hear some sounds, like water flowing or ice dropping. These sounds are normal. Occasionally, in periods of infrequent ice use, cubes may stick together and clog the dispenser. Remove the ice cream holder and lift up the ice bucket. Shake it from side to side to dislodge the cubes. Return the ice bucket and ice cream holder. Cubes should dispense normally now.
If You Do Not Use Ice Often
Older ice cubes can get stale. Clean the ice bucket periodically and use warm water to clean. Before putting it back, make sure to dry it so new ice does not stick to it.
When You Do Not Use the Ice Container for an Extended Time
If you will not be using the ice container for a long time, throw out the remaining ice cubes, wash the container with warm water, dry it with a towel, and put it back in the refrigerator. Then close the valve between the water supply and the refrigerator.
Using the Dispenser
Select one - crushed ice, cold water, and ice cubes - and push the ice/water lever gently as follows:
1. When you want crushed ice:
Press the selecting button until the crushed ice indicator is lit.
Push the lever gently with the cup. Crushed ice will be provided.
2. When you want cubed ice:
Press the selecting button until the cubed ice indicator is lit. Push the lever gently with the cup. Cubed ice will be provided.
3. When you want cold water:
Press the selecting button until the cold water indicator is lit.
Push the lever gently with the cup. Cold water will be provided.
When You Use Crushed Ice
Even if you are using cubed ice, you may still get some crushed ice. This can happen when several ice cubes are sent to the ice crusher.
Sometimes a small amount of snow or frost will form on the door in the ice chute. It is best to remove this to prevent ice from binding in the chute.
When You Use Cold Water
When you first push the lever, cold water might not come out immediately. This is because there may be air in the pipe. Press the lever for at least 2 minutes to clear out the air and then fill your cup with water.
The first cup of water may be warmer than the following cups. This is normal. If you take out 2 cups, or 16 oz., the
water may become warmer again.
To avoid injury, NEVER put your fingers and/or other objects in the ice dispenser
opening.
Warning
19
