Hampton Direct H15-LP1 Conversion KIT# 381-969 from NG to LP, LPG Conversion Kit Contains Qty

INSTALLATION

CONVERSION KIT# 381-969 FROM NG TO LP

THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER IF IN DOUBT DO NOT DO THIS CONVERSION !!

Each Kit contains one LPG Conversion Kit and one DC Sparker Kit.

LPG Conversion Kit Contains:

Qty. Part # Description

1904-575 Burner Orifi ce #55

1918-590 Label "Converted to Propane"

1908-528 Red "LPG" label

1904-529 5/3" Allen Key

1910-037 LP Injector (Pilot Orifi ce)

1918-479 Instruction Sheet

DC Sparker Kit Contains:

Qty. Part # Description

1820-475 Bracket DC Sparker

1820-476 Bracket DC Sparker

1904-153 Washer #8 External Star

1904-330 Nut 8-32 Hex

1904-438 Plug Nylon 0.750 Hole, Black

1904-531 Bushing Split Plastic

0.500 in.

1904-543 Screw 8-32 x 3/4 Pan Head

2904-553 Screw #8 x 1/2 Type "B",

Black Oxide

1910-073 Spark Generator Battery Holder

1910-074 Spark Generator Switch C/W Wire

1910-078 Battery Size AA

Energizer En91

2910-199 Clip Wire Holder

1910-903 Wire Fan To Power Cord Ground 30 in.

904-781 Velcro Hook, Black

904-782 Velcro Hook, Black

Installation of LPG

Conversion Kit:

3)Remove burner by removing the 2 screws on each side and then slide the burner to the left and lift out.

Screws

Note: Use a magnetic type screwdriver if possible.

Pilot assembly

is now

accessible

for steps the

following

steps.

4)Turn control knob to the “OFF” position.

5)Remove the black protection cap by hand from the high-low knob (Fig.1).

Fig. 1

7)Check that the screw is clean and if necessary remove dirt.

8)Flip the screw (Fig. 3).

Fig.3

9)Using the Allen wrench as shown in Fig.4, rotate the screw clockwise until snug, do not overtighten.

Fig.4

WARNING!

Do not overtighten the screw. Recommended to

grip the wrench by the short side.

10)Verify that if the conversion is from NG to LPG, the screw must be reassembled with the red o-ring visible (Fig. 5).

1)Shut off the gas supply.

2)Lift off Cast Top, remove Cast Front and Glass Door (refer to the glass replace- ment section in the manual) and carefully remove logs and lava rock.

6)Insert a 5/32” or 4mm Allen wrench into the hexagonal key-way of the screw (Fig. 2), rotate it counter- clockwise until it is free and extract it.

Fig.2

Red o-ring visible

Fig.5

LPG Configuration

Hampton® H15-1 Direct Vent Freestanding Gas Stove 29