Weld Diagnosis
Weld Penetration
Excess or | Proper | Inadequate |
Weld droops on top and | Weld is visible underneath and | Weld does not contact the joint |
underneath, or falls through | bulges slightly on top. | fully, just on the surface. |
entirely, making a hole. |
|
|
Cross Sections
Possible Causes and Solutions
1.Excessive material at weld: Reduce wire feed speed.
2.Overheating:
Increase welding speed and ensure that welding speed is kept steady.
Weld Not Adhering Properly
Gaps present between weld and previous bead or between weld and workpiece. See areas below.
Cross
Section
Possible Causes and Solutions
1.Dirty workpiece:
Make certain that workpiece is clean and free from oil, coatings, and other resi- dues.
2.Insufficient weld material: Increase wire feed speed.
3.Incorrect welding technique:
Place stringer bead at correct place in joint. Adjust workpiece position or weld angle to permit proper welding at bottom of workpiece.
Pausebrieflyatsideswhenusingweavebead. Keep arc on leading edge of weld puddle. Hold gun at proper angles as stated under Holding The Torch on page 19.
Possible Causes and Solutions
1.Workpieces too thick/close:
Joint design must allow weld to reach bot- tom of groove and allow proper welding procedures.
2.Incorrect welding technique: Maintain 1/2” or less stickout.
Keep arc on leading edge of weld pud- dle.
Hold gun at proper angles as stated under Holding The Torch on page 19.
3.Insufficient weld material: Increase wire feed speed.
4.Insufficient weld heat: Reduce Welding Speed.
Bend at joint
Cross
Section
Possible Causes and Solutions
1.Improper clamping:
Make sure that pieces are clamped se- curely in place.
Make tack welds to help hold pieces.
2.Excessive heat:
Weld a small portion and allow to cool before proceeding.
Reduce wire feed speed. Increase weld speed.
SKU 55525 | For technical questions, please call | Page 22 | |
Troubleshooting section at end of manual. | |||
|
|
