When the Weld is Completed | Harbor Freight Tools 55525 guide

When the Weld is Completed

21.Lift the Welding Wire completely away from any grounded object. Set the face shield down. Then, turn the Power Switch to its “OFF” position.

22.Unplug the Power Cord (13) from the electrical outlet. Then, make sure to set the Welding Torch (15) on a nonflammable, nonconductive surface.

23.NOTE: The wire brush/hammer can now be used to clean up the weld.

1.CAUTION! The weld may still be quite hot, and sparks/chips may fly when cleaning. Make sure to continue wearing ANSI-approved safety impact eye goggles and other protective wear when cleaning a weld.

a.The hammer can be used to knock off any excess spatter and to help knock down any ridges. Make sure not to damage the weld or material when striking it.

b.The wire brush can then be used to help remove oxidation and some fine spat- ter.

	SKU 55525	For technical questions, please call 1-800-444-3353;	Page 24
		Troubleshooting section at end of manual.

Image 24

Harbor Freight Tools 55525 manual When the Weld is Completed

Contents

For technical questions or replacement parts, please call 220 VAC*DUAL MIG Welder Contents Product Specifications General Safety RulesSave this Manual Work Area Electrical Safety Personal Safety Service Tool USE and Care Specific Safety Rules Industrial applications must follow Osha guidelinesPage Cylinders can explode when damaged Welding Produces toxic fumes and gasses Grounding Symbology UnpackingExtension Cords Grounded Tools Tools with Three Prong Plugs Assembly Instructions Face Shield AssemblyTo Install a Wire Spool To Attach The Handle To Route The Wire See Figure E Exercise Extreme Caution Risk of Fire AND/OR Electric Shock Figure F To Change Wire Settings See Figure GNozzle. See Figure F, previous Setting The Gun Polarity For Wire Type See Figure H To Install a Gas Cylinder Operating Instructions Before You Begin WeldingDuty Cycle Duration of Use See Figure K Setting Up The Weld See Figure L Holding The Welding Torch Figure M OttomB number is Wire HarsgCni ttSe eldWTop figures are Voltage On ETPage Weld Diagnosis Weld Penetration Weld Not Adhering ProperlyBend at joint Porosity Excessive SpatterStrike Test When the Weld is Completed INSPECTION, MAINTENANCE, and Cleaning Nozzle Inspection, Cleaning, and ReplacementContact Tip Inspection, Cleaning, And Replacement Or more for .030Tips .035 or more for .023 Tips Replacing The Welding Torch Liner Please Read the Following Carefully Parts Lists and Diagrams Wiring Schematic Parts List Part Description Qty Assembly Diagram Assembly Diagram Wire Feed Mechanism Troubleshooting Wire feed motor runs but wire does not feed properlyWire creates a bird’s nest During operation Welding arc not stable Welder does not function when switched on Wire Feeds, but arc does not igniteTroubleshooting Weak Arc strength Wire Feeds, but Shielding gas does not Flow WarrantyNozzle Plugged Regulator or cylinder valve closed