|
|
| |
| PRODUCT SPECIFICATIONS | ||
|
|
| |
Welding Current |
| 35 ~ 110 Amps | |
|
|
| |
Duty Cycle |
| 15% @ 110 Amps / 100% @ 35 Amps | |
|
| (Refer to chart and explanation on page 18) | |
Power Consumption |
| 220 Volt / 60 Hz / Single Phase / 24.5 Amps | |
|
| (Should be connected to a 25 Amp minimum dedicated circuit) | |
Open Circuit Voltage |
| 40 Volts Maximum | |
Required Power Plug Type |
| ||
|
| NEMA | |
Power Cord Rating |
| 14 AWG x 3C x 6’ Long | |
|
|
|
|
Gas Inlet Size |
| 1/ | ” |
|
| 4 |
|
Cables |
| Ground: 6 Gauge, 6’.................Torch: 8 Gauge, 6’ | |
Welding Wire Size |
| 0.23” to 0.035” | |
|
|
| |
Wire Spool Size |
| 4” Diameter | |
|
|
| |
Included Torch Tip Size |
| 0.030” | |
|
|
| |
Accessories |
| Wire Spool / Cylinder Strap / Wire Brush & Hammer / | |
|
| Spare .8mm & 1.0mm Welding Tips / | |
Net Weight |
| 53.5 Pounds | |
SAVE THIS MANUAL
You will need this manual for the safety warnings and precautions, assembly, oper- ating, inspection, maintenance and cleaning procedures, parts list and assembly diagram. Keep your invoice with this manual. Write the invoice number on the inside of the front cover. Keep this manual and invoice in a safe and dry place for future reference.
GENERAL SAFETY RULES
WARNING!
READ AND UNDERSTAND ALL INSTRUCTIONS
Failure to follow all instructions listed below may result in
electric shock, fire, and/or serious injury.
SAVE THESE INSTRUCTIONS
WORK AREA
1.Keep your work area clean and well lit. Cluttered benches and dark areas invite accidents.
2.Do not operate power tools in explosive atmospheres, such as in the pres- ence of flammable liquids, gases, or dust. Power tools create sparks which may ignite the dust or fumes.
SKU 55525 | For technical questions, please call | Page | |
Troubleshooting section at end of manual. | |||
|
|
