Replacing The Welding Torch Liner
1.Switch welder off, disconnect power, and discharge electrode to ground before proceeding.
2.Secure welding wire to the spool, cut it near the spool, and remove it from the torch and cable.
3.Gently twist and slide the Locking Collar (15b) off the torch and onto the Protective Sleeve (15a). Slide the Upper Housing (15m) forward and off the Lower Housing (15c).
4.Remove the four Screws (10g) that hold the Cable Clamp (10h) in place. Set aside the Cable Clamp, Screws, and the Liner Sleeve (10i) underneath the cable clamp.
5.Lay torch cable out straight to allow the cable to twist within the sleeve.
6.Press in on the
7.Install a new Liner and Fitting from the gun end with the end without a Fitting first.
8.Attach the Fitting at the end of the Liner (15k) to the
9.Slide the Liner Sleeve (10i) back onto the end of the liner. Reinstall the Cable Clamp (10h) and Screws (10g). Trim off the Liner that extends past the Clamp.
10.Make sure that all torch parts lay back into place properly including the Protective Sleeve (15a), Head Tube (15f), and Trigger (15d). See Assembly Diagram on page 30. While all parts are properly in place, carefully put the Upper Housing (15m) back onto the Lower Housing (15c) and slide back to secure. Slide the Locking Collar (15b) back onto the Housings (15c, 15m) and twist to secure.
11.Check the Torch (15) carefully for proper operation.
12.Route the Wire as instructed on page 12.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALI- FIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER.THE BUYER ASSUMES ALL RISK AND LIABIL- ITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
SKU 55525 | For technical questions, please call | Page 26 | |
Troubleshooting section at end of manual. | |||
|
|
