2.After you have programmed Preset stations (see below), either enter the Preset number (1 through 30) using the remote or use the Preset Stations Buttons (front panel or remote) to scroll through the list of presets.
3.In Auto tuning mode, with each press of the Tuning Buttons (front panel or remote), the AVR 247 will scan in the chosen direction until a station with acceptable signal strength is detected. Press the Tuning Button again to stop scanning.
4.In Manual tuning mode, with each press of the Tuning Buttons, the AVR 247 will tune the next frequency increment (0.1MHz for FM, or 10kHz for AM) in the selected direction. Press and hold the Tuning Button for faster scanning.
Figure 70 – Tuning a Station
Press the Tuning Mode Button
Figure 71 – Tuning Mode
To store a station in one of the 30 presets (see Figure 72):
1.Tune the desired station.
2.Press the Memory Button on the remote.
3.Use the Numeric Keys to enter the desired preset number.
Figure 72 – Storing a Preset Station
XM Radio Operation
XM Radio is a
OPERATION
NOTE: To listen to XM Radio using the AVR 247, you will need to purchase an XM antenna module and subscription, and you will need to activate your module. (Note that XM service is not available in Alaska or Hawaii.) Visit the XM Radio Web site at www.xmradio.com for more information.
Plug the module into the XM Antenna Jack on the rear of the AVR 247. Place the antenna module so that it has a clear view through a south- facing window in order to obtain reception from the XM satellite.
Select XM Radio as the source in one of the following three ways (see Figure 73):
1.Press the Source Selector button on the front panel repeatedly until XM Radio is selected. XM will only appear in the Message Display.
2.Press the Tuner Band Button
3.Press the XM Radio Input Selector on the remote.
Figure 73 – XM Radio Source Selection
You should be able to tune in Channel 1, the Preview Channel, to confirm that your equipment is ready for activation. There are three ways to tune an XM Radio channel (see Figure 70):
1.Enter the channel number directly using the Numeric Keys on the remote. It is not necessary to press the Direct Button first.
2.Press the Tuning Buttons on the front panel or remote to scan through the channels. Auto tuning mode is not available.
3.The AVR 247 is capable of storing up to 40 XM Radio preset channels. The presets are divided into five banks, denoted by the letters A through E, with eight numeric presets per bank. After you have programmed preset stations (see below), you may select one by pressing the Set Button repeatedly until PRESET SEARCH appears, then using the ⁄ /¤ Buttons to change the bank (A through E). Use the Preset Buttons to scan through the eight numeric positions within a bank.
When you are able to hear Channel 1, you are ready to activate your module. If you don’t hear Channel 1, make sure the module’s plug is firmly seated in the XM Antenna jack, and that the module is near a
Tune to Channel 0 for a display of your antenna module’s Radio ID number, required for activation.
The current channel number and preset location will appear in the upper line of the Message Display, and the channel’s name will appear in the lower line. Three
41
