System Configuration
Reset Levels: If you wish to start by resetting all of the levels to their factory defaults of 0dB, scroll down to this line and press the OK Button. The levels will be reset.
If you are using an external source to set your output levels, simply navigate to each channel, press the OK Button and use the M/N Buttons to adjust the level as desired between
If you would like to set your levels using the AVR 355/AVR 255’s internal test tone, adjust the TEST TONE line as follows.
Test Tone: This line determines whether the test tone is active. To begin the process of setting the levels, press the OK Button repeatedly to select the OFF,AUTO or MANUAL setting. Any time you manually move the cursor out of the channel listings area of the screen, this setting will auto- matically change to OFF,stopping the test tone.
When this setting reads AUTO, the test tone will automatically circulate to all channels, pausing for a few moments at each channel and then moving to the next channel several seconds later,as indicated by the highlight bar.You may adjust the level for any channel when the test tone is paused there by using the M/N Buttons. You may also use the K/L Buttons at any time to move the cursor to another line, and the test tone will follow the cursor.
When this setting reads MANUAL, the test tone will not move to the next channel until you use the K/L Buttons to move it.
NOTE: Setting the channel levels while one sur- round mode is active does not carry over to other mode groups. We recommend that after you have set the levels satisfactorily in one mode, you note the results and change to other surround modes. For those modes that don’t reflect your level settings, you may either copy the settings you obtained (as a short cut), or redo the procedure to determine the correct set- tings for those surround modes.
When you have finished adjusting the speaker levels, select the SAVE option so that the set- tings will not be lost. Record the level settings in Table A3 in the appendix for future reference.
ENGLISH
SYSTEM CONFIGURATION 27
