Hasselblad 949 manual Mounting and Unmounting the Slide Feeder, Mounting the Slide Feeder



Mounting and Unmounting the Slide Feeder

The procedures for both mounting and unmounting the Feeder to/ from your scanner require that you use the software-guided procedure described below, which ensures that the mechanical pars of the scanner and Feeder are correctly aligned for each step. Always use this software feature when you need to mount or unmount the Feeder. Otherwise, you may damage your Feeder and/or scanner. Also, the unmount procedure makes sure that the Feeder is correctly positioned for storage in its original box.

Important notice! Never mount or unmount the feeder with power switched on. It can cause damage to both scanner and feeder!

Mounting the Slide Feeder

Always use the procedure below to mount the feeder:

1.If you have not already done so, set up your Flextight 949 Scanner, connect it to your computer and install the FlexColor software as described in your scanner and software user manuals. Confirm that the scanner is working correctly by making a test scan using one of the standard original holders.

2.If there is still an original holder mounted inside the scanner, then remove it. Close the light table, if it is open, by lifting its front edge. See your scanner manual for instructions.

3.Position the Flextight 949 Scanner so that its front edge is aligned with the edge of your table. The Slide Feeder will hang over the edge of the table when it is mounted.

4.Make sure the scanner is turned on and launch the FlexColor software. If FlexColor is already running, then quit and restart the program.