Healthrider HATL51205.0 manual Assembly, Make sure that the power cord is unplugged

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor- mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included hex keys		and your own phillips screwdriver	and
wire cutters	.

Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is the key number of the part, from the PART LIST on pages 30 and 31. The number after the parentheses shows the quantity needed for assembly. Note: If a part is not in the parts bag, check to see if it is preattached to one of the parts to be assembled.

Internal Star	1/4” Washer	1” Tek Screw (40)–4	Extension Leg
Washer (113)–4	(39)–4			Bolt (80)–4

Console Bolt (89)–4

1. Make sure that the power cord is unplugged.

1

With the help of a second person, carefully raise the Uprights (97) to the position shown. Insert one of the Extension Legs (115) into the base of the right Upright. (Note: It may be helpful to tip the Uprights forward as you insert the Extension Leg.) Make sure that the Warning Decal (91) is in the indicated location.

Insert the other Extension Leg (not shown) in the same way.

91

97

115

6