Positioning the Logs
!BEFORE
FIRING THE UNIT
Follow these steps:
1.Release four glass clips and set the glass assembly aside.
CAUTION: The log assembly is fragile. Handle with care.
NOTE: See Step 9 when replacing the log set in an existing fireplace.
Figure 40
2.Carefully cut the cable tie holding the log assembly in place and discard the tie. Do not leave any part of the tie in the fireplace (see Figure 41).
WARNING: USE WIRE CUT- ! TERS. DO NOT ATTEMPT TO CUT THE TIE WITH A KNIFE.
3. Grasp the log assembly by the ends. Do NOT grasp the log as- sembly by the center. Remove the log assembly from the fireplace and set aside.
4. Remove the foam pad from the fire- place and discard. Make sure all piec- es of the foam are removed. With a screwdriver bend up the log place- ment tabs (see Figure 42).
Figure 41
Log Placement Tabs |
Figure 42
32 | Hearth & Home Technologies • 6000BE, |
