Flue Restrictor Instructions

CAP

STRAIGHT UP

VERTICAL VENTING

V (FT.)

40' MAX. (12.4 M)

NOTE: On vertical venting configurations over 10 feet install the flue restrictor (385-128). See flue restric- tor installation instructions.

Figure 6.

Straight Up Vertical Venting

1.Remove Exhaust Shield using a 1/4” nut driver by removing the four screws securing it in place (see Figure 7).

EXHAUST

SHIELD

FLUE

RESTRICTOR

Figure 7

2.Break the Flue Restrictor into two pieces. Do this by bending the part back and forth until it breaks (see Figure 8).

BREAK

HERE

Figure 8. Flue Restrictor

Hearth & Home Technologies • 6000BE, 6000BE-IPI • 2024-900 Rev. G • 11/05

Page 15

Image 15

Hearth and Home Technologies 6000BE owner manual Flue Restrictor Instructions, MAX .4 M Straight Up Vertical Venting

Contents

What to do if you smell gas Installation and Operation Safety and Warning Information Table of Contents Log Set Assembly Service Parts GLA-750TR Service Parts List 6000BE, 6000BE-IPI Intermittent Pilot Ignition Valve Assembly Standing Pilot Ignition 6000BE Certification High Altitude InstallationsInstallation Codes Appliance Certification Pre-install Preparation Introducing the Hearth & Home Technologies Gas FireplacesANY Such Action MAY Possibly Cause a Fire Hazard GAS Line Access Diagram of the 6000BE, 6000BE-IPI Constructing the Fireplace Chase Locating the FireplaceClearance Requirements Framing the Fireplace Framing Dimensions DVP90ST Identifying Vent Components Installing the Vent SystemVent System Approvals Tems or Components MAY be Used Flue Restrictor Instructions Vertical VentingMAX .4 M Straight Up Vertical Venting Chart Venting with One 90 Elbow Venting with ONE 1 90 Elbow Venting with Two 90 Elbows Venting with TWO 2 90 o Elbows Venting with three 90 elbows Venting with Three 3 90 Elbows + V 1 FT + H 1 FT Installing Vent Components Above the First 900 Elbow in the Venting System To Install the Heat ShieldInstall Support Brackets Continue Adding Vent Components 12 Hole and Vent Pipe Vent Termination Attic FirestopHorizontal Termination Alcove Applications Service Proper Positioning Leveling and Securing of a Fireplace Positioning, Leveling, and Securing the Fireplace Intermittent Pilot Ignition IPI System Installing the Optional Heat-Zone Kit Gas Control SystemsVice Must be Wired Directly to the FIRE- Place Junction BOX Standing Pilot Ignition System Check for GAS Leaks Gas Supply LineGas Pressure Requirements Pressure Natural Gas Propane Wall Switch Wiring the FireplaceFor Standing Pilot Ignition Wiring Appliance Requirements Optional Accessories BRN Operation using Battery Power Installing Trim, Logs, and Ember Material Installing the TrimFinishing Positioning the Logs Follow these steps Cover Ports Shutter Settings Glass Assembly Placing the Ember Material6000BE Tempered 6000BE-IPI Tempered Double-check for faulty components Cold Climate SwitchBefore Lighting the Fireplace Important Turn OFF the GAS Before Servicing Your Fireplace After the InstallationFireplace Maintenance Lighting the Fireplace

Hearth and Home Technologies 6000BE owner manual Flue Restrictor Instructions, Vertical Venting

Models: 6000BE

VERTICAL VENTING

40' MAX. (12.4 M)

Straight Up Vertical Venting

Flue Restrictor Instructions

Figure 8. Flue Restrictor