Placing the Ember Material
Ember material is shipped with this gas fireplace. To place the ember material:
•Pull the four glass latches out of the groove on the glass frame. Remove glass door from the unit (see Figure 45).
LATCHES
(BOTH BOTTOM
AND TOP)
GLASS
ASSEMBLY
Figure 45.
Glass Assembly
•Embers CANNOT be placed directly over ports. Care should be taken not to cover the lighting trail of ports (from back to front).
•When placing Glowing embers onto the burner care should be taken so that the ports are not covered. Place the embers along side the port trail, but not on or in between the ports (see Figure 46). Failure to follow this procedure will likely cause lighting and sooting problems.
•Place Mystic embers on areas of base refractory away from port holes. Use this material to give your fireplace a realistic ash bed.
•Save the remaining ember materials for use during fire- place servicing.
•Replace the glass door and a front trim door on the unit.
•Pull out and latch the glass clips into the groove on the glass frame.
EMBER MATERIAL
Figure 46. Placement of the Ember Material
Glass Specifications:
6000BE: TEMPERED
6000BE-IPI: TEMPERED
Hearth & Home Technologies fireplaces manufactured with tempered glass may be installed in hazardous locations such as bathtub enclosures as defined by the CPSC. The tempered glass has been tested and certified to the require- ments ofANSI
This statement is in compliance with SPCS 16 CFR Sec- tion 1201.5 “Certification and labeling requirements” which refers to 15 USC 2063 stating “…Such certificate shall ac- company the product or shall otherwise be furnished to any distributor or retailer to whom the product is delivered.”
Some local building codes require the use of tempered glass with permanent marking in such locations. Glass meeting this requirement is available from the factory. Please con- tact your dealer or distributor to order.
34 | Hearth & Home Technologies • 6000BE, |
