DVP90ST

DVP4

DVP6

DVP12

14-1/4

	12-3/16	2
	MAX.	2
	MAX.	MIN.
		MIN.
		24
	DVP12A	36

9-7/8	DVP24
	DVP24
	45.0O

10-1/4

DVP45

DVP36

11-1/4

7-1/4

1-1/4 TYP

DVP48

8-9/16

1/2 TYP

12-9/16

NOTE: PIPES OVERLAP 1-1/4 INCHES AT EACH JOINT.

Figure 4. DVP-Series Direct Vent Component Specifications (5-inch inner pipe / 8-inch outer pipe)

Hearth & Home Technologies • 6000BE, 6000BE-IPI • 2024-900 Rev. G • 11/05

Page 13

Image 13

Hearth and Home Technologies 6000BE owner manual DVP90ST

Contents

What to do if you smell gas Installation and Operation Safety and Warning Information Table of Contents Log Set Assembly Service Parts GLA-750TR Service Parts List 6000BE, 6000BE-IPI Intermittent Pilot Ignition Valve Assembly Standing Pilot Ignition 6000BE Installation Codes High Altitude InstallationsAppliance Certification Certification Introducing the Hearth & Home Technologies Gas Fireplaces Pre-install PreparationANY Such Action MAY Possibly Cause a Fire Hazard GAS Line Access Diagram of the 6000BE, 6000BE-IPI Locating the Fireplace Constructing the Fireplace ChaseClearance Requirements Framing the Fireplace Framing Dimensions DVP90ST Vent System Approvals Installing the Vent SystemTems or Components MAY be Used Identifying Vent Components Vertical Venting Flue Restrictor InstructionsMAX .4 M Straight Up Vertical Venting Chart Venting with One 90 Elbow Venting with ONE 1 90 Elbow Venting with Two 90 Elbows Venting with TWO 2 90 o Elbows Venting with three 90 elbows Venting with Three 3 90 Elbows + V 1 FT + H 1 FT Installing Vent Components Install Support Brackets To Install the Heat ShieldContinue Adding Vent Components Above the First 900 Elbow in the Venting System 12 Hole and Vent Pipe Attic Firestop Vent TerminationHorizontal Termination Alcove Applications Service Proper Positioning Leveling and Securing of a Fireplace Positioning, Leveling, and Securing the Fireplace Vice Must be Wired Directly to the FIRE- Place Junction BOX Installing the Optional Heat-Zone Kit Gas Control SystemsStanding Pilot Ignition System Intermittent Pilot Ignition IPI System Gas Pressure Requirements Gas Supply LinePressure Natural Gas Propane Check for GAS Leaks For Standing Pilot Ignition Wiring Appliance Requirements Wiring the FireplaceOptional Accessories Wall Switch BRN Operation using Battery Power Installing the Trim Installing Trim, Logs, and Ember MaterialFinishing Positioning the Logs Follow these steps Cover Ports Shutter Settings Placing the Ember Material Glass Assembly6000BE Tempered 6000BE-IPI Tempered Cold Climate Switch Double-check for faulty componentsBefore Lighting the Fireplace Fireplace Maintenance After the InstallationLighting the Fireplace Important Turn OFF the GAS Before Servicing Your Fireplace